|
Instruction of ASC PU Transfer |
 |
1)Make
target design by computers. Switch on the cutting plotter and
better try the pressure of tool in the first step: After cutting, the color layer as well as one layer of base paper can be easily removed at the same time. |
 |
2)The tool should just cut half thickness of the base paper. |
 |
3)There are many colors of PU vinyl transfer you can choose. |
 |
4)Set the speed according to the size of the design. For example, set the speed faster (at 50-75) for a large design, and at 25 definitely for a small one. Pressure is about 150g.Carve the design by following the instruction of cutting plotter. Lower speed cutting is very important! |
 |
5)Peel
off the unwanted part when finish cutting. Remove the color
layer as well as part of the base paper at the same time from
outside to inside or in an opposite way. (The base paper is thick enough that can be separate by layers. Peel between paper and paper, no film and paper) |
 |
6)The design on base paper should be complete without any deletion. If you peel the wanted parts ,you can press it back then continue. |
 |
7)Do
not overly set the pressure of the heat-press-machine. Set the
temperature at 150℃-175℃(310F-350F) and the time in 15 -
20seconds. The temperature & time is not absolute, You should adjust on actual status. |
 |
8)Put the pattern on the printing stock properly and place Teflon sheet on top then heat-press. |
 |
9)Cool peel the base paper.If it fails because of low temperature, you can use a drier to heat the paper and then remove. |
 |
10)A wanted design will be on your unique T-shirt completely. |